Sling Pilots Forum

Has anyone run into an issue with the long range tank rib 27 assembly fuel feed line fitting obstructing rivet? I tried installing fitting opposite direction, same issue. Will contact Sling Technical and update.

Per Sling Technical

• Install nut and washers in place on AN 90º fuel feed fitting.

• Drill hole into nut (3.3mmm) for rivet but do not drill into threads.

• Install trimmed rivet (smallest length—of the 3 segments on shank, cut 2 off). The rivet also works as a locking pin.

• Apply tank sealant over nut fitting and rivet.