The revised fuel level arm detail (sheet 27) in DC-KAI-002-X-F-6.4 does not work, for me at least.
The 181mm is way too long. What gives??
Thanks!,
Joe
#slingsupport
Re: New Fuel Level Sender Bending Detail
Posted: Thu Jan 12, 2023 10:16 pm
by Sling Technical Official
Hi Joe
You need to slide the fuel level sender base closer to the fuel tank root rib and drill 2 new mounting holes for it.
Make sure you have good clearance between the float ball and WG-RIB-204.
The new kits will have the holes drilled in the correct position.
You need to slide the fuel level sender base closer to the fuel tank root rib and drill 2 new mounting holes for it.
Make sure you have good clearance between the float ball and WG-RIB-204.
The new kits will have the holes drilled in the correct position.