Sling Pilots Forum

Just as an example, here is how I did mine.

https://eaabuilderslog.org/?blprojentry ... tcat=&sid=

Not sure if others have this same variance...on my kit for both the left and right fuel tanks, the end rib (WG-RIB-202-R-F-3 Fuel Tank Rib 202), came with the tooling hole punched to 6mm not the 4.8mm the plans call for. Therefore, the 1x 983 sealed rivet called for on sheet 28 would not work. This ...

Checking here one more time before moving on with build. Have not been able to obtain comparable pictures of both left and right fuel senders installed anywhere, so posting my tank pictures below for comments. Flipping the left fuel sender over does get the 180 ohms reading when tank is full so assu...

Does anyone have pictures of both the left AND right stock fuel level senders orientation when installed they can share? Specifically the float arm view.

#slingsupport

Wings - on revision 6.1 of the wing manual on sheet 4 it says to use 25x 993 (4.8x10mm) rivets on the rear spar double/triple plates. The rivets need to be 4.8x15mm - also got reply from factory support confirming. This became more clear in later steps when attaching ribs 1-5 to the rear spar where ...

Here is a small mod to the plans for the VS VOR antenna installation. The goals were to forego cutting notches on the top of the skin/top rib and keep the rivet line buttoned up and a little cleaner. With a “T-shaped” nylon 6/6 spacer (cut from 2.5 inch diameter) it hangs the internal puck about 5/8...

Send me a private message on this forum with your address to ship to and you can borrow mine.

I got a good response back from the factory to clarify. It looks like for now, nothing is done with these four left skin/bracket holes and M3 rivnuts until ready to install the trim servo. The M3 rivnuts are actually for attaching to the trim servo itself and the buttonhead screws attach through the...

Thanks for the info on prior elevator question. The next unclear item is related to the Trim Servo Mounting Bracket. It was simple to attach to the spar/rib. This bracket plate has four holes on the bottom that are 4.0mm. The left skin has four holes that are 3.2mm that line up. There are four M3 ri...

Working on the elevator spar assembly and got to where you add the center channel. There are two long center plates that go in between the center channel and the spar (step 6 in the manual). I got one of the two in and figured I would stop and check with the forum before moving on. It was easy to ge...