Sling Pilots Forum

Hi Steve.

Unfortunitly not.
Typically custom paint schemes and the like are handled internally or privately.
Due to the nature of our info we is will not pursue this either.

Thanks.

The main baggage compartment and extension have been tested to a specific baggage weight. If we were to increase this, testing would have to be done and relevant documentation updated. For this reason, we are not going increase the maximum baggage weight in the near future. I suggest placing heavier...

Good Day.

There has been no conformation or updates from Rotax Regarding the extention of the TBO.

Good day. We have sevral aircraft registered in European countries like, France, Italy, and Austria to name a few. The certification documentation typicaly required by your local aviation authority unfortunitly cannot be shared with you as the kit builder, as this is IP. We will however be able to s...

Good day At this stage we don't foresee major changes getting made to the firewall forward kit. We will be able to confirm this after completing the required tests. We will make an upgrade kit available for the guys who already have a 915 firewall forward and fuel system kit if its necessary. Regard...

Good day guys We plan on making it available for the TSI as well after completing all the engineering and flight testing required. The additional max power will further improve the take off and climb performance of the TSI but we should see the same cruise performance with max continuous power. The ...

Hi guys

The inside side skins are not structural. Fitting them with rivnuts and screws wont affect the structural integrity of the fuselage.

Hi Joe

You need to slide the fuel level sender base closer to the fuel tank root rib and drill 2 new mounting holes for it.
Make sure you have good clearance between the float ball and WG-RIB-204.
The new kits will have the holes drilled in the correct position.

Regards
Armin

Hi,

We are not offering it as an option currently. The limitation lies with some of the equipment used (flap actuator, trim servo, lights etc.). We will consider it as an option in the future, but it will be some time still.

Dear Brian, We have 4 main suppliers for rivets, please see the table below for supplier details for the various rivets: https://www.dropbox.com/s/0ksjf4crq4nec22/Rivet%20supplier.jpg?dl=0 Note: If you cannot see the image in this post, right click on the image icon and select "Open image in ne...