Sling Pilots Forum

Good day

The wires from your regulated heated pitot will run to the regulator box. The box can be mounted on the inspection hatch next to the pitot cut out.
The two wires in the will provide power to the regulator box.
Here is the wiring diagram:

Good day

My apologies for the late response. Can you please send some pictures and possibly measurements of the misalignment caused by the short cables to our technical email address (technical@slingaircraft.com) ?

Hi Brian

These videos that Evan put together will be uploaded and available from 1st April.

Hi guys My apologies for the delayed response. The rear seat base attaches to the rear fuselage close to the hinge point with 3 Dzus fasteners only. The Dzus spring gets rivetted to the rear fuselage and the Dzus cam screw gets installed in the rear seat base as shown in the manual. The two holes in...

You could fit the 915 as long as you stay within the flight, weight and C of G limitations. The aircraft has never been fitted with one before.

The instructions are not clear enough and we will add the required information. The bottom row of rivets can be rivetted from the front as you mentioned.

Hi Brian, Thank you for bringing this to our attention. At the moment we only have data up to 9 000 ft ISA and this does appear in the Sling 4 TSi POH. We are in the process of updating our POHs and will update this data. We shall include data up to the service ceiling of 18 000 ft ISA. If you have ...

Yes you can purchase additional inspection panel kits. It does not have the same structural integrity as the wing skin. You can send a mail to our technical team (technical@slingaircraft.com) for acceptable inspection hatch placement.

Thank you for the feedback. We will update page 18 with the new position of the GMU 11 bracket.

Hi guys The struts need to be attached to the doors. Place a spacer of approximately 50mm between the doors and tape them together to hold them open. Bolt the aluminum angle brackets to the bottom of each strut and position them inside the canopy. Mark and drill the holes in the canopy. The holes mu...