New Fuel Level Sender Bending Detail

[Joe Azzarelli]

The revised fuel level arm detail (sheet 27) in DC-KAI-002-X-F-6.4 does not work, for me at least.

The 181mm is way too long. What gives??

Thanks!,
Joe

#slingsupport

[Sling Technical Official]

Hi Joe

You need to slide the fuel level sender base closer to the fuel tank root rib and drill 2 new mounting holes for it.
Make sure you have good clearance between the float ball and WG-RIB-204.
The new kits will have the holes drilled in the correct position.

Regards
Armin

[Joe Azzarelli]

Hi Joe

You need to slide the fuel level sender base closer to the fuel tank root rib and drill 2 new mounting holes for it.
Make sure you have good clearance between the float ball and WG-RIB-204.
The new kits will have the holes drilled in the correct position.

Regards
Armin

That makes sense. Thanks for the response!

Joe

[STGove]

I have been looking at this:

https://ciescorp.net/products/magneto-r ... uid-level/


Thoughts?

[ibgarrett]

This was my video on using the Cies Fuel sensors in my SlingTsi build